Independent guide. We are not an electrician or electrical contractor, we do not do electrical work and we are not for hire. Chattanooga requires electrical businesses to hold a City electrical license. Check any electrician before you hire them.

Chattanooga Electrician GuideIndependent guide for Chattanooga and Hamilton County · not an electrician

Generators and storm prep in Chattanooga: transfer switches, permits and costs

Updated November 16, 2026 · Independent guide, not an electrician

Safety: If you see sparks, smell burning or a power line is down, stay away and call 911. Report downed lines and outages to EPB.

Chattanooga's grid is heavily automated, but severe storms still take down poles and lines. This page covers what a generator can and cannot safely do, the transfer switch that connects one to a house, how permits work in the city and county, and what generators cost at national rates.

Storms that knocked out power here

On the night of April 12, 2020, an EF3 tornado crossed Hamilton County. The National Weather Service office in Morristown estimated peak winds of 145 mph, a Tennessee path of 15.25 miles and a maximum width of 1,500 yards. Its survey traced damage from the Harris Hills area to East Brainerd Road, where an auto parts store was leveled, then through the Drake Forest and Holly Hills neighborhoods and on into Ooltewah near the Summit Softball Complex. The survey notes areas "blocked by tree debris and fallen power poles." (NWS Morristown public information statement, April 16, 2020, archived by Iowa Environmental Mesonet) The statement lists 3 fatalities and 19 injuries for the tornado.

Most outages are smaller. EPB says its Automated Grid uses more than 1,400 switches that reroute power automatically and has cut outage minutes by 55% since launch (EPB, Automated Grid), while its storm page warns "there may be times when you may experience a longer outage." (EPB, Storm Readiness)

Why outages matter more in an all-electric city

About 73% of occupied homes in the City of Chattanooga heat mainly with electricity (57,819 of 79,084), per ACS 2020 to 2024 five-year estimates. Across Hamilton County the figure is about 68%. (Census Reporter, ACS 2024 5-year) A winter outage in most local homes means no heat. Electric heat is also a large load, which affects generator sizing.

Portable generator safety: EPB's rules

EPB's generator page lists these points (EPB, Generators):

The transfer switch

A transfer switch connects a generator to selected circuits or the whole house while isolating the home from EPB's lines. Angi's national generator guide says whole-house units are hardwired to the panel and need a transfer switch, and that about $1,200 of a typical installation goes to that wiring. Angi describes automatic-start standby generators as safer because they prevent back-feeding, "which sends power back to the electrical grid and can seriously injure or kill utility workers." (Angi, generator, national) Angi's general electrician guide lists installing a generator transfer switch at $400 to $2,500 nationally. (Angi, electrician cost)

Permits and licenses

A transfer switch or standby generator connects to the building wiring, so it is permit work. Inside the city, a City Class I or Class II licensee pulls residential electrical permits. (City of Chattanooga, Electrical Permit)

Angi lists natural gas and liquid propane among standby generator fuels. (Angi, generator) A gas or propane connection is separate gas work. Hamilton County, for example, issues separate electrical and gas permit forms. (Hamilton County, Building Permits) Ask whether your installer handles both trades or brings in a licensed gas contractor, and confirm both permits are pulled.

Published costs (national)

No Chattanooga-specific generator prices were found. Angi's 2026 national figures (Angi, generator):

Item National figure
Average whole-house generator installation $5,154
Typical range $1,509 to $8,799
Portable generators (1 to 7.5 kW) $500 to $2,000
Partial-home generators (9 to 20 kW) $2,000 to $6,300
Whole-house generators (22 to 48 kW) $5,000 to $18,000
Concrete pad, 3 by 6 feet about $1,000
Labor and installation $1,500 to $5,000
Permits $50 to $200
Annual maintenance $80 to $300

Sizing for a Chattanooga house

Angi's national rule-of-thumb sizes by floor area: 6 to 9 kW for 1,000 square feet, 7 to 10 kW for 1,500, 10 to 14 kW for 2,000, and 12 to 16 kW for 2,500, while stressing that a professional load calculation is more accurate. It lists an electric furnace at 5,000 to 25,000 watts. (Angi, generator) In an electrically heated home, decide early whether the generator must carry the heat. Covering only essentials (refrigerator, lights, internet, a few outlets) is far cheaper than covering an electric furnace or heat pump.

A storm checklist for Chattanooga households

From EPB's storm and outage pages (EPB, Storm Readiness; EPB, Outage and Storm Center):

  1. Pick a safe room in the center of the home, ideally windowless, on the lowest floor.
  2. Build a kit: flashlights, battery radio, phone charger battery pack, water, first aid kit.
  3. Keep daily medications nearby when a storm is forecast.
  4. Report outages through the MyEPB app, by texting "OUTAGE" to 423-648-1372, or by chat.
  5. Treat every fallen line as live and call 911 if you encounter one. (EPB, Downed Power Lines)

Frequently asked questions

Can I plug my generator into a dryer outlet?

No. EPB warns against backfeeding a home through an outlet because it can cause fire or electrocution. (EPB, Generators)

Do I need a permit for a standby generator?

Yes for the electrical connection, under the City's permit rule, plus a gas permit where a fuel line is added. Angi puts permit costs at $50 to $200 nationally. (Angi, generator)

Is a portable generator enough?

Angi's national guide says a portable generator may be enough if you only need to power a few critical items, and that high-demand loads such as a water heater or furnace point toward a whole-home unit. (Angi, generator) Connecting a portable unit to house circuits still calls for a transfer switch rather than an outlet.

Sources for this page (11)
  1. https://mesonet.agron.iastate.edu/api/1/nwstext/202004161807-KMRX-NOUS44-PNSMRX
  2. https://epb.com/outage-storm-center/generators/
  3. https://epb.com/outage-storm-center/storm-readiness/
  4. https://epb.com/outage-storm-center/
  5. https://epb.com/outage-storm-center/downed-power-lines/
  6. https://epb.com/energy/automated-grid/
  7. https://www.angi.com/articles/how-much-does-it-cost-install-generator.htm
  8. https://www.angi.com/articles/how-much-does-it-cost-hire-electrician.htm
  9. https://api.censusreporter.org/1.0/data/show/acs2024_5yr?table_ids=B25034,B25035,B25003,B25040,B01003&geo_ids=16000US4714000,05000US47065
  10. https://chattanooga.gov/pay-and-apply/permits-applications/electrical-permit
  11. https://www.hamiltontn.gov/BuildingInspection_BuildingPermits.aspx

Check a license yourself

Service guides